What determines the price of rfid electronic labels: the analysis of chips, envelopes and volume factors
RFID Knowledge

What determines the price of rfid electronic labels: the analysis of chips, envelopes and volume factors

PublishedShanghai Zejie Smart Technology Co., Ltd.

RFID labels are priced by chip selection, form of encapsulation, order volume three core costs, antenna design, frequency, use of the environment, surface process, and these additional items also allow prices to float up or down. The normal UHF nudity inlay can press a large unit price (over 100,000) at around $0.3, and the single price for industrial finished labels with ABS shell usually falls between $3 and $10 or higher.

Why do the chip costs weigh most on RFID labels?

The chip is labeled "brain", which determines storage capacity, protocol support and security levels, where the difference starts to rise.

How does the sealing affect the unit price of the label?

The seal refers to the process of turning chips and antennas into a "workable label" with very different forms of price.

The "special seal" of high-temperature laundry labels, metal surface tags and windshield labels for vehicles often fall between 5 and 50 yuan at hard costs mainly on the material and process difficulties of the outer shell.

How low can the order load keep the price?

Order volume is the biggest lever in RFID tag price negotiations. Moving from an order in the thousands to one in the millions can result in a two- to threefold difference in unit price.

If the project requires a million units of volume, the nudist play phase usually uses the chip lock price to maintain the same price band with subsequent and stable supplements. Shanghai-based Chettech, while co-opting large projects, will split the volume order from the subsequent supplement, using a large bill to press the chip cost, and secure the priority of the delivery by using a stable patch.

What other factors would make the same label offer different?

These details also cause differences in the final offer once chips, seals and batches are excluded.

What should be done when purchasing RFID labels to control their overall cost?

By making these elements clear, the negotiations have been set to a bottom. The following lessons have been validated in most projects.

In general, the price of RFID labels is not what suppliers say, but chips, caps, lots of three hard costs plus frequencies, environment, personalization of these soft options one layer at a time. These are often cross-checked before the procurement, and the overall cost is pushed down. If the project involves multiple containment forms or higher requirements for chip compatibility, the supplier can make the alternative clear at the selection stage, avoiding subsequent situations where the single chip is missing and forced to re-design.