How do we choose RFID asset location management? Programs and equipment configuration
Industry News

How do we choose RFID asset location management? Programs and equipment configuration

PublishedShanghai Zejie Smart Technology Co., Ltd.

When the warehouse is counted, the handheld reads the asset label without knowing whether the equipment moves between the storage area, workshop or floor. The key to the RFID asset location management program is pre-positioning and updating the frequency, then matching the tags, reading and writing devices with the site network; it is usually easier to identify by region when precise coordinates are not required.

No equipment found at site: first, let's get this "location" clear.

The same asset may need to know which storage area it is in, and may need to track its real-time location within the plant. The two types of equipment are different. RFID is a technology that uses radio wave identification tags, but "read to label" does not mean "get accurate coordinates." Zreader usually gives the range where the labels go first, depending on the device's location, the type of label and the physical environment.

The label is not stable: first, the material and location of the installation

The common trouble in the selection is that when labels are placed inside a metal cabinet, the reading behaviour is different from that of an open environment after a liquid container or device. Metals and liquids affect wireless signals, the placement direction of labels, the screening and the distance between the reader and the labels change the readability effect. It cannot be concluded by merely label appearance or single test results.

Shanghai Select Technologies, Inc., when it combes the RFID asset management needs, uses the material of assets, labels, regional boundaries and business processes to evaluate them together. The purpose is to get equipment configured for on-site problems rather than modeling them before moving to the site.

Equipment configuration is not ready: unlist by identification point

The number of equipment should not be estimated by area only. The plane map should indicate the entry, shelf area, equipment concentration area and point of contact to be recorded, then configure the equipment according to identification. A base list usually includes labels, fixed or hand-held readers, antennas, positioning stations (when real time location is used), network equipment, management software and installation of accessories.

Inappropriate position after online: check and check to find deviation

The pilot acceptance should be done around the actual business: label assets, read the register, move across the region, check the records and check whether they are complete. Separately, it is possible to measure the proportion of assets that have been successfully identified, not the case where the tags have been misread, the event has been delayed uploading, and the location of the search is consistent with the physical area on the site. The specific receiving/receiving threshold values should be set by the user in conjunction with the asset value and management requirements, and it is inappropriate to apply uniform values without an on-site basis.

When you configure the program, you write questions for answers: know where the asset is in, when it passes through the entrance or if you want to keep looking at space; then test with typical assets and real motion lines, finalize labels, read-written devices and network configurations. Valuate precision needs, read stability and maintain them, usually less subsequent adjustments than only compare the device parameters.