How can RFID print passive electronic labels guarantee a good rate?
Industry News

How can RFID print passive electronic labels guarantee a good rate?

PublishedShanghai Zejie Smart Technology Co., Ltd.

Print-passive RFID labels should not be summed up by “last readable” only. Conductor continuity, size, solidification and chip connection can lead to different failures.

Manufacturing quality requires evidence in the process.

A sample can read a number, but only indicates the success of this reading and cannot substitute for validation of power abundance, durability and batch consistency.

The good rate rise should be distinguished from the failure of the antenna to the chip.

Test thresholds and equipment drift should also be included in the control.

Lowering the test threshold may increase the eligibility rate, but deliver marginal samples to the client.

The improvement of the good rate requires locating the defect to material, antenna graphics, chip connections or test determination. If only the final bad rate is counted, it is not possible to know whether the modification is effective. The batch and process conditions should be preserved so that the lapse can be traced back, rather than simply removed at the end.

Why isn't one success enough?

The increase in the number of peripheries of a label, even if it is provisionally eligible, may presume that the process drifts. Keep distribution instead of only the qualifying results, and you can detect trends earlier. Manufacturing quality management should focus on how much more time is left from the failed border, not just whether or not it crosses the line today.

Process distribution is of more diagnostic value than individual qualified findings

When performance moves closer to the failed border, the two-digit statistics of qualification and non-conformity may not change for the time being. The retention of test configurations and distribution of results will help identify batches of material, process drifting or equipment changes. The reference is used to monitor the testing system, while the marginal samples are used to observe abundance, which is different. The improvement measures should be compared back and forth under consistent conditions, and it should be verified that no bad transitions to subsequent processes have been made.

Don't just look at the successful samples.

Observation dimensions Evidence to be retained
Process Retroactivity Material batches, platforms and process versions are available for inspection
It's consistent. Comparison of thresholds and dispersions under the same conditions
Bad closed circle The results of the failure analysis return to design or process
This is the key trade-off. When the good rate looks better, is it the manufacturing process that's getting better or does the test standards go away?

It's recommended that this be verified.

Retain the reference and negative samples, track changes in parameters by process, compare the distribution of thresholds and batch separations rather than see a composite percentage.

It is recommended that raw materials, process parameters, detection configurations and poor types be recorded in batches and that electrical failure be separated from appearance failures.

It's worth asking.

When the good rate looks better, is it the manufacturing process that's getting better or does the test standards go away?

Technical and factual references