How much is the rfid hand-held terminal?
RFID Knowledge

How much is the rfid hand-held terminal?

PublishedShanghai Zejie Smart Technology Co., Ltd.

The RFID handheld terminals range from a few thousand to tens of thousands, and the buyers are often struggling with "buy cheap or expensive" -- but "can this configuration hold up their own use?" The test is four variables: frequency bands, reading-writing distance, protection level, and the cost of software integration. It's clear that if you align these to your actual needs, the price is not reasonable.

Overall distribution of price ranges

The common RFID handheld terminals are in roughly three tranches by industry grade:

Within the same tier, quotes vary by 20–30% between vendors, mostly because of system integration and differences in service.

Hardware configuration: hard indicators for determining prices

Frequency distance from reading and writing

The RFID is divided into three main bands of the LLF, HF-HF, and UHF-UHF. The HHF is the main source of logistics storage, with a distance of up to 10 metres and the highest cost for modules; the HF is used more for paper, security, and less expensive for modules; and the LF is used in such settings as animal identification, at the lowest price. If the same terminal supports the MHF+HF double frequency, the price will be much higher than a single-frequency version.

Protection level and fall-over.

The industrial scene has a much greater impact on the equipment than the office scene. IP65 is a common protection floor, which can protect from dust and low pressure water column wash; if you are to fall down at a height of one metre and work properly, drop tests will have to reach a concrete standard of more than 1.5 metres. Each upgrade of protection increases the body mass, seals, and the cost of strengthening the screen.

Scan engine

Many of the RFID handheld terminals are a one-dimensional/two-dimensional scan. One-dimensional laser engines are cheaper, two-dimensional video engines are more expensive, but they read screen codes, wear blurs, and use more ebbing over time. If you add a remote scan head, the price will go up.

Software and services: easily neglected portions of the quotations

Hardware is only half of the cost of procurement, and the other half tends to be on software and services:

When comparing the offers, the details of these "software+services" are shown separately and the real difference between the two offers is often apparent.

Application of scenes and procurement recommendations

When the budget is limited, think clearly about how to use it:

For larger purchases, usually more than 50 units, negotiate a volume discount with the supplier. The total reduction is typically around 10%-20%. Custom housings, interfaces, or firmware incur separate development fees and usually have minimum order requirements.

The first contact with the RFID handheld terminal team can be a small-scale test of 1-2, and then a large-volume purchase decision. Shanghai-based Siexi technology finds in project delivery in many industries that clearly uses frequency and typical reading scenarios to make suppliers more precise in their configurations and avoid additional costs associated with later upgrades.

It's a few pits that can be easily trampled when choosing.

Taken together, RFID holds no standard price for the terminal, but only a reasonable price to match the scene. The selection is much clearer if four variables are filled in using frequency, reading and writing distance, environmental complexity, and integration difficulty.