Current state of development and selection of nationally produced nfc chips
RFID Knowledge

Current state of development and selection of nationally produced nfc chips

PublishedShanghai Zejie Smart Technology Co., Ltd.

The national NFC chip has been fast-moving in recent years, and the use of door-barriers, a cartoon, and labels as alternatives to imports is already stable. But when it comes to financial payments, identity cards, and high security levels, the import chip remains the dominant.

Cost: Gaps concentrated in low and medium capacity segments

The NFC chips are broadly divided by function into two categories: pure tag chips, mainly for forgery protection, logistics, post-trigger; and encrypted or controlled reading and writing chips, which are closed, paid, and identified. The cost advantages of a national chip are concentrated in the first category, with single prices often being only half or less of the same product imported, and high-end chips with safety modules, with relatively small differentials.

The cost of delivery is also considered in addition to the unit price. Importing chips has been unstable in their supply cycle for recent years, often from the next order to receipt more than 12 weeks, and then they need to be replaced by a substitute verification when there is a shortage of them. The national chip usually runs from the bottom to the sample for 2-4 weeks, domestic containment tests, and local technical support response is faster, and it is relatively friendly for small and medium-sized projects.

Performance and compatibility: Base function leveled, high security level gaps still exist

NFC works at 13.56 MHz, and the mainstream protocols are ISO/IEC 14443 Type A/B and ISO/IEC 15693, and the NFC Forum defines the label type of Type 1 to Type 5. The national chip is more mature in the Type A protocol and NDF data format, and it is almost equal to the main mobile phone system, daily cell phone triggers, posters are used to detect a little bit of a lack of sense.

The first is that the Type B and some of the Japanese agreements support incomplete, partial domestic bus cards, early use of non-Type A protocols for school cards, and full coverage of national chips requires a single-by-one verification. Second is high security certification, such as the International Security Certification in Financial Payments (CC EAL5+), which currently has few certified national chips, and imports still dominate. Three are supported by national secret algorithms, with some of the national cores having SM4 modules, but their universality is still improving.

Apply scenario: rank by scene, then chip selection

It is clear that common applications are in three stages according to security phase and compatibility requirements:

First, pure trigger and recognition class.So, like smart home-based networks, NFC label posters, logistics traceability, security. This kind of thing is not about safety, it's about cost and compatibility, and the national chip is basically good in this set, and some of the projects are worth a half of the material.

Second, door-barrel and identification class.The company's entrance, a campus tom, member-server cards, and the attendance system. This requires some encryption (usually AES or 3DES) that requires reading and writing distance and response speed. The middle end of the national chip is basically satisfied, but it is more secure to confirm the compatibility of existing card readers, haircard systems.

Third tranche, finance and governmentAnd, including the financial-grade flash card, the mobile flash card, the social security card, the ID reading module. These are mandatory certification and protocol requirements, the national chip must be pre-certified, and now imports the chip is in absolute advantage, and it is recommended that the mature program that has been certified should be preferred.

Select the common pit: something outside of datasheet

The first pit is to focus on the datasheet. The success of the NFC project is often not in the chip itself, but in antenna design and resistance. The same chip is matched by a different antenna, which can be read and write from 2 cm to 8 cm, and can be pressed within 1 cm. At the sample stage, several antenna scenarios are measured, so don't wait for later.

The second pit is the SKK difference that is underestimated. The repository of the national chips, the command set, the initialization process varies considerably, and it almost rewritten from one to another. If the project moves from imported chips to domestic production, the rewrite of the code is evaluated in advance, leaving the development cycle open.

The third pit is supply stability and long-term availability. Some of the national chip models are closed for a year or two, and they are very risky for projects that require long-term maintenance. They are selected by those who have been intergenerationally selected, and are still in the main source of delivery, so as to avoid becoming "orphan material."

The fourth pit is the omission of certification and compliance requirements. Medical, financial, and government projects have mandatory certifications, and the chip itself has been certified and the product has been certified, two things: to confirm that the chip certificate covers your product form.

How do we start: set the scene, then make a real picture?

In the first contact with the NFC, this sequence is followed: first, to specify which of the three tranches above should be applied; to list the agreements that must be supported (Type A/B, NDEF etc.); to frame a 2-3 candidate chip for 2-3 samples each to measure the antenna match and read-write distance; and to verify compatibility and goodness in the final small batch. Shanghai-based Cheeks and Technology, Inc., has largely moved along this process in its multi-year NFC program practice, settling down a more stable selection assessment template.

Overall, the NFC chips are triggering identification, door-bans, and the medium- and low-end label scene has stabilized to meet most of the project needs, with real costs and delivery advantages; finance, government, identity cards are read to such scenarios that have a hard security requirement, and it is recommended that at this stage, the import programme for certification be chosen, and that countries' chips be switched after they have been certified.