RFID labels, electronic tags, radio frequency labels.
RFID label procurement “industry secrets” are often not mystical algorithms, but different quotations and performance descriptions imply different conditions: antenna size, materials, condition, sampling and after-sale range.
Trade secrets are usually the condition of unwritten tests.
The same chip can be used for different antennas and seals, and the final expression cannot be a chip model.
It is difficult to compare with the “read rate” that does not specify the distance, direction and installation of the test. Recoverable configurations and reference samples should be maintained.
The results are compared with the results of the sample setup, power, load and failure. Buyers should ask for restrictions rather than treat unrecoverable demonstration advantages as a product secret.
Situations requiring early verification
When the power of the test equipment or the threshold is adjusted, changes in the eligibility rate cannot be immediately attributed to improved production. The system should be stabilized by reference and batches made more often. Otherwise, neither buyer nor buyer may draw different conclusions around the same label, but they cannot prove where the difference originated.
It's recommended that this be verified.
The storage and configuration of samples, which are separated by small batch retrospects, is the cause of poor statistics rather than a combined pass rate.
It is recommended that raw materials, process parameters, detection configurations and poor types be recorded in batches and that electrical failure be separated from appearance failures.
Manufacturing quality requires evidence in the process.
A sample can read a number, but only indicates the success of this reading and cannot substitute for validation of power abundance, durability and batch consistency.
Process distribution is of more diagnostic value than individual qualified findings
When performance moves closer to the failed border, the two-digit statistics of qualification and non-conformity may not change for the time being. The retention of test configurations and distribution of results will help identify batches of material, process drifting or equipment changes. The reference is used to monitor the testing system, while the marginal samples are used to observe abundance, which is different. The improvement measures should be compared back and forth under consistent conditions, and it should be verified that no bad transitions to subsequent processes have been made.
Let's look at the input and the results.
| Observation dimensions | Evidence to be retained |
|---|---|
| Process Retroactivity | Material batches, platforms and process versions are available for inspection |
| It's consistent. | Comparison of thresholds and dispersions under the same conditions |
| Bad closed circle | The results of the failure analysis return to design or process |
| This is the key trade-off. | Are the parties to the procurement using the same performance terms to express completely different test results? |
It's worth asking.
Are the parties to the procurement using the same performance terms to express completely different test results?

Ms. Lei
Mr. Pang