Focus on autonomous RFID technology applications to promote intelligent manufacturing standard research
Industry News

Focus on autonomous RFID technology applications to promote intelligent manufacturing standard research

PublishedShanghai Zejie Smart Technology Co., Ltd.

Discussion of autonomous RFID technology and smart manufacturing standards, the core is not a source label for equipment but whether key links can be understood, tested and maintained on an ongoing basis.

Autonomous technologies should be available for replacement and certification

The coding, radio frequency protocols, control interfaces and business events are at different levels. The adoption of open standards facilitates interoperability, but specific compatibility needs to be validated; self-study software should also retain the data that can be exported.

If the system is only in a single-supplier undisclosed format, the replacement of follow-up equipment and cross-plant collaboration may be limited.

The interface and contract should allow the export of identity, event and configurations to prevent historical records from being replaced with equipment. The ability to continuously interpret their own production data supports long-term autonomy more than if a model were purchased at a time.

Automatic recognition must access the process state, not by-pass display

Reading success should only be the input of a process judgement and cannot skip the locking or security control of the device.

Split end-to-end beats into positionable time

From work to identifiable areas, to action by the device, usually through triggers, reading, validation, interface transmission and control response. Each section may be waiting, and normal averages do not represent the most unfavourable condition. If a judgement is needed in a limited window, the delayed distribution of the entire link should be measured and the safety or business status of the service after time has elapsed should be clarified. Only wireless reading can be optimized, and no interface queued; only additional software retesting may also make an old task effective after the work has been removed.

An easily ignored reversal.

When you replace a reader, the business interface and data format must be changed to indicate that the system boundaries are not clear enough. Interoperating should be validated by replacement, rather than just by standard names in specifications. For users, moving assets and data constitute long-term autonomy.

Put your judgment in the real situation.

Select an interface for a replacement test to check whether the historical identity, process data and unusual records of the equipment after the switch are still available.

It is recommended that production events be recorded in the observation mode, which does not change the action of the equipment, and that the worksheets, works and processes be checked for consistency before they are gradually entered into production judgement.

How many bases do you have to decide what's worth?

Observation dimensions Evidence to be retained
Process Map Can you match the correct work with the same re-use?
beat impact Time for recognition, verification and response
Unusually isolated. Identification anomaly cannot be extended to an uncontrollable line.
This is the key trade-off. When suppliers stop maintaining, do plants still have the capacity to interpret and migrate their own production data?

It's worth asking.

When suppliers stop maintaining, do plants still have the capacity to interpret and migrate their own production data?

Technical and factual references