What should be taken into account in the asset inventory? Data accuracy and process specifications
RFID Knowledge

What should be taken into account in the asset inventory? Data accuracy and process specifications

PublishedShanghai Zejie Smart Technology Co., Ltd.

The inventory is not necessarily an error in number or a discrepancy in the booking deadline, asset tags are removed or the liability is changed to unregistered. The asset count requires clarity about scope, calibre, on-site verification and processing of differences, with a reviewable record to allow for accurate results and process discipline.

Before the count: I can't match the bill. Check the scope and calibre first

When an inventory is prepared at a storage site, it happens that the equipment has been moved to another location and the billboards are still in place; the temporarily borrowed tools are also attached to the original responsible person. Without first determining the scope of the count and the cut-off date, the on-site records may not be directly comparable with the booking data.

The inventory should be preceded by a clear identification of the asset class, storage area, base date for the inventory, and the statistical calibration of the use, idleness, maintenance, loan status. When compiling the list of assets, at least check the asset number, name, specification, number, location, liability and state; the item is marked separately with missing or duplicate numbers, not directly incorporated into the normal list. In combing such processes, Shanghai Cheatech will place the "Base-Scope-State Definition" in the same inventory statement, reducing the number of different groups' records per one calibre.

On-site verification: assets are seen and records are identified

At the scene, the inventory should be field-by-area, not just number, but also physical and billboard numbers, names and locations. The bar code or label can be used for rapid identification, but when the label is vague, offline or unreadable, it should record alternative identifiers and take photographs or fill in abnormal notes to avoid speculation about asset identity on the basis of appearance. When multiple partition counts, you draw the area boundary and record the counter, reviewer and time to complete, and reduce double count or missing.

At a minimum, records should distinguish between “no accounts” and “no accounts” and “not information”. Assets are found to have been moved, lent or repaired, and no direct changes should be made on site; the original records and situation at the scene should be maintained and the flow documents verified by the responsible person. The corrections on the inventory table should leave a mark, with the modifications indicated, for reasons, date and operator, ensuring that follow-up is retroactive.

Disposition of variances: review of reasons and update of desk accounts

After the inventory is completed, the results of the site are compared to the base desk account item by number, location, responsible person, status or asset identification and verification responsibility is assigned. For example, the account shows that the equipment is in Area A, while the site is in Area B, checking the transfer records first; if no record is available, confirm whether an unregistered transfer has occurred, rather than changing the position of the table account to Area II directly. The discrepancy conclusion should be accompanied by a supporting document or statement, the review followed by an update of the desk account following the internal approval process, and maintain an inventory list, a list of discrepancies and a record of approvals.

Forming norms: to have the next inventory documented

Upon completion of the round of inventory, it is recommended that a check be made to verify whether there are no project owners and processing deadlines, whether the desk account update is consistent with the approval results, whether paper or electronic records can be retrieved by asset number. The inventory range, time, personnel, anomalies and disposals are archived, and tag maintenance, asset transfer registers and periodic spot checks are incorporated into daily management. In practice, you can select a regional test disk, check list fields and process differences, and then extend them to other regions; this will allow both timely detection of calibration problems and easier review of the count results.