RFID Common Fault Scrutinization of Industrial Carriers: A Practical Method for Resolving Reading Failures and Data Losses
The RFID industrial code is read and written frequently in the industrial environment, which inevitably affects productivity by failure to read and write.
Reading failure is a common problem for many reasons. If, because of signal interference, metal work or liquid containers reflect on frequency signals, which leads to readers not identifying labels, you can move the carrier to non-metal areas, or select anti-metallic labels and increase the isolation layer. Distance and angle deviations also cause problems, with readers exceeding 90 degrees or an angle away from labels, signs decline, and the reading/writing position needs to be adjusted to ensure that distance is within a valid range and vertically aligned to labels. If label surface contamination, oil pollution, dust cover hinders signals, and the label surface is wiped out by industrial alcohol. In addition, the device parameter is wrong, if the reader has a low power or a different frequency, and re-corrects the parameter. The reference label indicates the power and frequency.
The loss of data is not common, but has serious consequences. Physical damage to labels, such as chip breaks, antennas fall, and many new tags need to be replaced with protection measures for the location of the installation due to severe collision or high temperature burning. The reading and writing process is broken, a sudden break in power leads to failure in data writing, data verification mechanisms should be set up on MES systems, read back immediately after writing, and rewritten without success. Conflicts between encrypted protocols may also lead to data loss, data disorder or loss when different brand names Zreader are incompatible with tag encryption agreements, and equipment branding or upgrade protocol versions need to be harmonized.
Checks if labels are loose or not, and the label signal strength is detected on a monthly basis with special equipment, which is replaced in a timely manner when it is below -80dBm. At the same time, a malfunction log is established, a high frequency failure point is measured, and the installation of environmental or equipment parameters is optimized.

Ms. Lei
Mr. Pang