What are the advantages of using RFID for a fixed assets inventory? Efficiency and accuracy resolution
The main advantage of the RFID count is that, when labels can be identified by a reader, they collect information in bulk and reduce the number-by-case sweep and manual entry; their accuracy depends on the tag, the reading and writing environment, the asset desk account and the review process. It is suitable for the situation where assets are numerous, dispersed and with high inventory frequency, and cannot be a substitute for the verification of differences in accounts.
Element 1: Mark and write by asset type first
RFID is radio frequency recognition, and reads label information by radio wave. The fixed asset inventory is commonly UHF-RFID, which is suitable for mass reading at a certain distance; metal equipment, liquid containers or areas with complex electromagnetic environments, which may affect the readout effect, requires a combination of asset material and field testing of choice tags. Handheld readers are appropriate for area-by-area inspection, and fixed reading/writing devices are more appropriate for continuous identification at entry and exit or specified areas.
When selecting a type, you can first sort out the asset class, the shell material, set density and inventory routes, and then select representative assets for reading. Metal cabinets and regular desks are not suitable to apply the same label solution; stickers should also avoid coverings and easy wear. Recording these conditions reduces the error or error in the formal count.
Point 2: Align labels with asset desk accounts
Each asset should have a distinct electronic label number and be matched with the number of the asset in the billboard, name, use department and location. Check if the code is duplicated or the information on the account is complete; and fix data first, and then start a batch count. RFID increases the collection efficiency and does not automatically correct the wrong account.
Shanghai-based Selecting Technologies, Inc., when combing these processes, links labels, takes an inventory of areas and differences into consideration in the same design. For users, it is not just stickers, but to ensure that read numbers are matched to a recognisable, traceable asset record.
Point 3: Inventory by region and review of discrepancies
Splits the floor, room or storage area into an inventory unit, reading and retaining the time of the count by region, operator and area information. The system compares the results to a due list, forming differences such as read assets, unread assets and off-book labels. When you have unread records, check first whether the tag is dropped, if the device is blocked, then rereading the reading/writing distance or angle; if it is still not possible to confirm, then manual checking.
The accuracy should not be seen only in how many records the device reads, but also in whether the physical is consistent with the system results. It can be recorded during the pilot phase, misreading and repeating readings, analysing reasons by region, asset type, repositioning labels, reading parameters and walking paths. Results at different sites are influenced by metal reflections, label orientation, asset intensity etc., which do not allow for a single accuracy rate to summarize all items.
Element 4: Assessment of efficiency gains based on the frequency of inventory counts
Manual scans usually require asset tags and article-by-article operations; RFID can identify multiple labels in one reading, so assets are concentrated and a well-routed area is more likely to reflect efficiency gains. Actual time saved is to be used through the same region, compared with the trial disk records of the same asset, statistical preparation, reading, review of differences and collation of results, rather than just comparing the speed of reading on site.
If the number of assets is small, fixed and inventory is low, the proceeds of adaptation may be limited; if the asset is widely distributed, mobile or audit requirements are high, volume capture and traceability are more valuable. It is recommended that a typical regional test disk be selected, the labels be matched, data matching and discrepancy processing processes are determined, and then the application is expanded.

Ms. Lei
Mr. Pang