What is the RFID asset inventory program? Design element resolution
RFID Knowledge

What is the RFID asset inventory program? Design element resolution

PublishedShanghai Zejie Smart Technology Co., Ltd.

A landing RFID asset inventory program, with four cores - the RFID electronic label, a reading and writing device (with handheld terminals and fixed-readers), backstage management software, and data interface with existing ERP or asset management systems. RFID is a non-contact automatic recognition technology that uses radio frequency signals to identify target objects and to read and write data, each of which involves selection, deployment and parameter setting, following specifications to avoid most of the implementation traps.

Element 1: RFID label selection - align identification distance and asset material first

The label selection directly determines the recognition rate and inventory efficiency of the package, with two parameters being identified:

Paste also has a specific location: Metal surface assets (such as servers, machine boxes) suggest that metal labels or non-metallic areas be placed in flat form, at least 1 cm from the edge of the metal, to avoid the signal being blocked. The pasted is followed by a writing test to confirm that reading distance and angle are expected, which is often saved, and the site is missing.

Element 2: Reading and writing equipment configuration - handheld, portals, fixed reading and writing sets by scene

The more the reading and writing equipment, the better it is, the more the whole scene is to be counted in order to balance efficiency with cost:

The actual project is usually used in three types of combination: a tunnel door flow, a fixed reader to make a regional inventory, and a handheld to final review and blind zone supplement. When Shanghai-based Chetting Technologies Ltd. was working on a programme for a room customer, it used the "Clockgate plus Handheld" combination to record the equipment's entry and exit and to quickly check the accounting date.

Element 3: Backstage management software - Inventory process and permission design is central

Once hardware is in place, software is the key to bringing up the efficiency of an inventory. A complete set of RFID asset counts backstages typically contain these modules:

Two lines are recommended in the inventory mode: a timed automatic count (fixed-reader run, and then sent to the administrator) and a manual periodic count (revealed monthly or quarterly handheld), which is mutually verified, and "right book but lost" in one way.

Point 4: Data interface - real access to RFID data in asset management systems

If the RFID inventory system does not connect to ERP, asset management systems, data is only an island.

Point 5: Several pits that can easily be stepped on during implementation

A complete list of programme delivery

The following minimum elements should be included in a programme to take care of a qualified RFID asset inventory:

  1. On-site survey report: coverage area, asset type and quantity, distribution of metals and liquids, existing network conditions.
  2. List of label selections: frequency, chips, containment specifications, pasting location maps.
  3. Equipment deployment map: fixed reading/writing, access door, handheld plaque position and antenna angle.
  4. Software functionality list and flowchart: take stock of tasks, anomalies, privileges settings.
  5. Data interface scheme: interface document, field control table, sync frequency.
  6. Implementation of the plan and training programme: phased access, operational manual, inventory staff training.

The programme document is written at such a level of detail that the implementation phase will be largely non-flag. If the project involves multiple floors, multiple warehouses and complex asset types, it is recommended that this list be used as an acceptance standard at the solicitation or project setting stage to reduce later decoupling.