RFID Fragile Label Installer Curriculum: 3 Notes to Avoid Label Fragmentation Impact Identification
RFID Knowledge

RFID Fragile Label Installer Curriculum: 3 Notes to Avoid Label Fragmentation Impact Identification

PublishedShanghai Zejie Smart Technology Co., Ltd.

RFID Fragile Label Installer Curriculum: 3 Notes to Avoid Label Fragmentation Impact Identification

1. Caution I: Selecting pairs to install surfaces to avoid material and morphological risks

RFID is fragile for the fragile base of a fragile label, and prior to installation you have to select flat, dry, non-oiled, non-combust surfaces such as smooth cardboard on the pharmaceutical packaging box, flat plastic casings on new energy batteries. If installed on the side (e.g. cylinder, arc box component), make sure that the curve radius is not less than 5 cm - too small a curve would cause the label fundamental to stretch over, and can be slit when pasting, affecting antenna signal transmission.

At the same time, rough or porous surfaces (e.g. sandy plastics, varnish paper) that may lead to stickers being insufficiently attached and subsequent minor collisions may be broken out; if there is oil or water stain on the surface, they need to be wiped clean and then installed, otherwise the oil will damage the labeled film layer, resulting in the paste ' s failure.

2. Caution II: Control of adhesive strength to avoid physical damage

Paste with soft scratches (such as silk-coated, plastic card) which will be applied to the center of the label edge, and which will be better matched by a gel... and it is forbidden to press the center or edge of the label with a fingertip -- when the fragile base is under local pressure, there are visible microfirings that will lead to an identification failure when the antenna breaks.

If the label is to cover part of the stitch (e.g., food packaging seals), pasting should be fixed at one end and slowly smoothed to the other, avoiding the graft of the label; if it is pasted and a position is found to be shifting, no direct torn adjustment - tearing can cause the base to break in an instant, new label must be replaced directly, and a food firm test shows that the correct control will reduce the rate of damage from 15% to 2%.

3. Caution III: Avoiding sources of interference and ensuring the stability of identification

Installation location is required to be far from the edge of the metal (not less than 3 cm) and liquid storage area: Metals shield RFID signals, and if labels are attached to metal components (such as metal casings for new energy chargers), reading distance will shrink from 10 m to 1 m; liquids absorb radio frequency signals, which may result in... unidentifiable if placed directly above the liquid area of bottled drinks.

In addition, it is necessary to avoid the position of friction in product use (e.g. near a bagman, where the battery is plugged out), long-term frictions can wear and tear the label surface or even cause the base to break. After avoiding the source correctly, the tag recognition success rate will be above 98%, ensuring subsequent trace, and the security function is functioning properly.