Application of NFC seal labels in asset sealing management
The cold chain stop of a third-party medical logistics company, late at night, went to a car full of biological agents, the receiver cleared the outer case and noticed that two of the boxes had small scratches on their plastic seals. He was thinking about three cases of anomalous sealing -- in the last six months, the same line had been blocked, and then the retrace pointed to being unsealed while being transported, which was not even visible from the traditional lead seals. The warehouse began this year with the NFC seal, essentially trying to get the seals destroyed, and the physical test for upgrading to data level.
NFC (Near Field Communications, Near-up Communications) sealing labels are not an emerging concept, but the central idea is to put a single NFC chip with antennas in one-time silence, close the antenna and close the phone to read the only number of the chip; once the seal is ripped, the antenna breaks, the chip loses sensor power, the phone can never read that ID. The attribute "physical destruction is ineffective" makes it particularly suitable for a one-time seal on asset packaging.
Traditional seals of blind areas exposed in asset management
Before introducing NFC, most warehouses were sealed in three types: plastic card buttons, lead seals, one-time stickers. They can distinguish between seals and unenclosed on the visual side, but if the tool is ready to unseal them, then they will be embedd with a replica of the original, at almost zero cost.
And the more difficult thing is to trace it back. The seal usually has only one number, and the inspector takes the number into the form, and then goes back to the problem, and finds that the number and packaging are not right -- either the number is changed or the form itself is a patch. The whole chain, "Who moved this seal at what time, where?" is broken.
For high-value assets, precious equipment, cold-chain drugs, and for people who are the subject of physical evidence, sealing is not just a tool to prevent theft, but a link in the chain of compliance. The audit depends on whether it is sealed or not, but whether it has been touched by anyone since. Traditional seals do not give answers to the latter question.
How does the NFC seal "disruption" end?
The key to embedding the NFC chip in a one-time seal is at two points: the source of the chip ' s electricity supply and whether the antenna was damaged.
The chip doesn't need batteries. It's powered by a mobile phone radio field.
The NFC label is a passive radio frequency tag, and does not have batteries. When the NFC antenna sends out 13.56 MHz's radio frequency field (according to ISO/IEC 14443 and ISO/IEC 15693), the internal antenna loop senses into an electromagnetic field, re-routing the chip, then reconnecting the data back to the cell phone.
This mechanism means that the chip in the seal is readable as long as the antenna is intact; once it breaks, the chip is out of power, and the phone is not read -- the tag becomes dumb. The seal is destroyed, from visual judgment to a 0/1 data signal.
Antenna design to bind to sealing structures.
It is common practice to set a soft antenna in the direction of the length of the seal, crossing the bounds of the bite. When it is sealed, it bites the physical connection of the antenna on both sides of the face and closes the circuit; the back road is cut when the seals are torn open.
Some more mature types of structures:
- One-time sticker sealAn antenna is printed on the PET base, placed on a wrapper, torn off
- Plastic card button sealAn antenna through the lock-tip tongue structure, and when it is unlocked, the lock-tanger cuts apart.
- Pull-off seals: antennas are vertically laid along zips, pull out of the zipping and break
The choice of type depends on the size, shape and point of stress during transport. In the course of a project, we usually look at the receptivity analysis of the packaging itself before deciding which antennas go by - details but directly affects the reliability of failure.
Read: Only ID, NDEF data and operations records
The NFC read about three levels:
- UID (sole serial number): The only chip in the world, 7 bytes or 10 bytes, burned out of the plant and unrewritten, is the foundation of retroactivity
- NDEF data: an internally written storage area of the chip (NDEF is a NFC data exchange format) that can be written to, for example, asset numbering, time of encapsulation, operator
- Operations System Log: Every reading calls the back-office interface, records who, when, what equipment, which UID read.
To make the third level solid, the entire sealing management changes from "inth" to "data." A label is read several times, and who last read it, the time read and GPS position are all in the system. Just check out the logs when you're in trouble, and no paper records need to be turned over.
A few practical problems that can't be avoided during landing.
It seems to be clear, really in the production environment, and if a few things are not handled, sealing itself is a setup.
The selection depends on storage capacity and encryption.
Common NFC chips are NTAG213 (user area 144 bytes), NTAG215 (504 bytes), NTAG216 (888 bytes) and MIFIARE Classic series. Asset sealing is usually only one ID and short text, NTAG213 is sufficient; if more information is needed or signed to verify, it can be placed on NTAG216 or encrypted.
For scenarios involving compliance, monitoring physical evidence or high-value assets, it is recommended that chips with digital signature capability or NDEF Signature be selected to allow the reading end to verify the authenticity of the label content and avoid rewrites of data on the tag.
The environmental resistance of labels needs to be matched with transport conditions
NFC tags generally have etched aluminum or copper antennas and PET or paper housings. In cold-chain conditions (−20°C to 8°C) or in damp or oily environments, conventional seals can lose adhesion, their antennas can oxidize, and read range can decline.
The cold chain transport projects usually assign labels for low-temperature glue and rembranding, with surfaces then waterproof coating. Read distance is also affected by temperature, and the same label is measured at a reading distance of 5 cm below 25 °C, which may be about 2 cm to -18 °C. This needs confirmation at the selection stage with suppliers, so that it is not found on site.
Cover operation and back-office interface
The label itself does not address management issues, but the system behind it is at its core. It is common practice to connect NFC tags and WMS (storage management system), TMS (transport management system) or asset management system:
- EnclosedStorers sealed, NFC put on the phone, trigger backstage to write to the time of the sealing, operator, associated asset ID
- Transport linksDriver or transporter post at the transit point to record arrival time and geographic location
- Receiving and Inspection: Receiving party NFC first reading, compared to UID's consistency with shipping records; failure to read or UID's inconsistency is considered a sealing anomaly
When this process is smooth, sealing anomalies automatically enter the waiting list and no longer rely on manual inspections to detect problems. Logistics enterprises usually need to work with software providers to develop interfaces that are much more expensive than simply buying labels, but also yield more tangible benefits.
The cost is not just a single label.
The market is usually one-off NFC seals for a unit price between a few cents and a dollar or two, and it's more expensive to have an encrypted signature or special cover. But in the asset management scene, not only does it cost itself, but also manual citation, inspection, retroactive costs after problems.
For enterprises with large assets and long transport chains, the upgrade of sealings has resulted in more compliance and retroactive certainty.
Actual changes after use
After returning to the first-class cold chain medical logistics scene, which replaced the NFC seal labels, several common changes included:
- When the timing of the seizure is unusual, then the reset is turned into a live sweep, and the alarm triggers.
- The processing time for anomalies has been reduced from two to three hours of monitoring, paper records to minutes of the retrieval system log.
- The rate of complete sealing, anomaly rates, operator performance within the system becomes a statistically measurable indicator, with problems positioned to specific routes and nodes
- The sealing system records became retroactive at the time of annual compliance audits and no longer relied on manual back-up
The longer-term benefit is that the sealing move has changed from a physical activity to a statistical data act. The manager can see the rate of closure per batch, the anomaly rate, the operator's performance, not the question of whether the seal was broken, but the "which line, which nodes were too high." This is a step from experience management to data management.
NFC seals are not intended to replace all traditional seals -- plastic seals are still enough in many low-value scenarios. The real problem is to turn a seal from a visible object into a signed evidence. When the value of assets or compliance requirements are high enough to be "seigned abnormally liable," the NFC seal labels provide the technical base for this ability to trace.
If the business involves a large number of high-value or compliance assets that require one-time sealing, it is recommended to clear three things: size and transport environment of the subject under seal, feasibility of backstage system interface, capacity for abnormal processing. These three things make it clear that NFC seals will be better off than you think. Shanghai-based Chee Jieh Tech has project implementation experience in the direction of RFID and NFC tag applications, from label selection, structure design to backstage interface, and can give a landingable solution based on actual scenes.

Ms. Lei
Mr. Pang