How does the firm's fixed asset management software work?
RFID Knowledge

How does the firm's fixed asset management software work?

PublishedShanghai Zejie Smart Technology Co., Ltd.

Directly to answer: The fixed asset management software counts, essentially "to check the physical assets and system cards with a swipe or mobile phone end", three steps at the core -- downloading the inventory tasks, field scans or manually recording, submitting discrepancies. The remaining report output, depreciation recalculation, and reconciliation are done in one key in the system. These links are then removed.

How does an inventory mission create and postulate?

The administrator creates a new inventory list in the back of the software, which is often based on: Name of the inventory (named by year/month/sector), Range of the inventory (corporate, by sector, by asset class, by location), Method of the inventory (sweeping or manual) and deadline. Once created, the system automatically pushes the pending asset list to the phone-end or PDA of the person on the board.

The list contains the words of the asset number, name, specification, location of storage and book number. A list of a medium-sized company (approximately 2,000 asset cards) is normally generated and issued within one minute.

How can a live inventory be better?

There are two main ways to do this:

Scanning disc pointsThe inventory operator uses a bar code or two-dimensional code on a mobile phone or a PDA to scan a single item of the system by automatically ticking "discretioned" . A single person can drive 300-500 assets per day, suitable for a warehouse, a production workshop, and this is an asset-intensive scene.

ManualThe inventory clerk searchs and ticks the system by number. This is a slower approach, suitable for old assets, temporary inventories or if the asset is not labelled.

If the asset does not have a bar code, you can print a label in advance with a mass of software -- usually using a combination of an asset number + name + two-dimensional code, in a visible position. A batch of 1,000 tags will take approximately 30 to 40 minutes for a common label printer.

What if the results of the inventory and system data are not matched?

This is a problem that happens in an inventory. The system automatically divides assets into three states:

These discrepancies are summarized in the discrepancy statements, and managers can see which department, which location has the highest rate of discrepancies, and send people to review them. The general difference is normal within 0.5%, and over 1% requires a focus on whether the leak or the tag mislabeling.

What reports can be exported after the count is completed?

The statement function is the core value point of the fixed asset management software, which determines whether finance and auditing can be used directly.

Can the report format and fields be customised?

Most software supports custom fields and report templates.

The template is set up once and can be used repeatedly, with a time frame for the release of the template when an asset inventory is performed at the end of each year.

How do we get the count up?

A few practical experiences:

1. Clear data before inventory counts.Long-term inactive, obsolete cards that have not been reduced for disposal are cleared after the process is completed or these "dead assets" will be consistently recorded at the time of inventory, affecting efficiency.

2. The inventory is divided by location.For example, if your company has three office areas and two warehouses, do not issue one master count sheet. Split it into five sheets and have one team per area count in parallel.

3. Use the "blind disk" approach.The inventory officer does not take the billing list, but only takes a blank list to the spotboard and then checks it out.

4. Short training for inventory staff.Sweeping, submitting differences and dealing with common problems (e.g., what if they cannot be cleared) can be done in 20 minutes.

Let's wrap this up.

The fixed asset management software counts, essentially by "undertape - on-site scan or manual entry - differential processing - report output." The reporting function is at the heart of the system and determines whether finance and auditing can use data directly.

If the current software inventory is manually Excel and the statements are financially separate, it is recommended that a new tool that will allow automatic system-runs be replaced as soon as possible, save enough time to conduct two round rounds of full-time inventory.