How to ensure the durability of RFID labels? Waterproof, friction resistant design elements
RFID Knowledge

How to ensure the durability of RFID labels? Waterproof, friction resistant design elements

PublishedShanghai Zejie Smart Technology Co., Ltd.

Waterproof design: Interrupting water vapour erosion and adapting to multi-species environments

Waterproofing is the basis for ensuring the dampness of RFID brand electronic labels, and a protection system must be constructed from the three aspects of the base, encapsulation and interface. Base selection gives priority to polyamide (PI) or modified polyester film, which is highly waterproof in itself and is not transmutable within -40°C to 85°C temperature zones, saturated clothing water wash, outdoor storage etc.; if higher water-resistant levels are required, they can be coated on the surface of the foundation, with PTFE coating, and waterproofing up to IPX7 (30 minutes per day in depth of 1 metre).

The sealing process is required to avoid leaks in the water, and recommends a heat pressure-coated sealing process that binds the top and lower base of the labels closely together by high temperature pressure, which is within 0.1 mm of the width of the suture, while also covering nano-resistant glue at antenna and chip welding, preventing water from leaking through the welding point into damaged circuits. For clothing requiring frequent water washing, PET waterproofing can be added and 50 standard water wash (40°C water temperature, conventional scrubber) tested to maintain normal recognition.

II. EFFECTS DELIVERY DESIGN: ENHANCE THE PRETTY, PURSUANT TO THE USE CURRENT

The friction-resistant design needs to balance surface hardness with flex, avoid labeling in transport, and use the embracing loss effect. For surface treatment, the UV solidification coating is used, the hardening of the surface can reach H level (lead hardness test), the friction factor is reduced to 0.2, after 1,000 back-to-wig tests (500 g load) there are no visible scratches on the label surface, and the information readability success rate remains at over 98%.

Use tough composite substrates, such as polyester reinforced with glass fiber, to improve tear resistance, and round the edges with at least a 1 mm radius to reduce wear at corners. For washable clothing tags, embed the tag between layers of fabric with only the necessary identification area exposed. This prevents direct rubbing without affecting comfort. Reinforce the connection between chip and antenna with a ribbed structure to resist stretching and abrasion and prevent circuit breaks.