A common nano-program that briefly introduces the RFID chip.
Industry News

A common nano-program that briefly introduces the RFID chip.

PublishedShanghai Zejie Smart Technology Co., Ltd.

When discussing the nano-program of RFID chips, it is important to avoid moving the dissemination methods of logical chips directly to label chips. Smaller cut points do not decide on a single label to read further.

Manufacturing quality requires evidence in the process.

A sample can read a number, but only indicates the success of this reading and cannot substitute for validation of power abundance, durability and batch consistency.

Chip production is not a single item of label performance.

The passive chip involves a design trade-off between the front end of the radio frequency, currents, storage and power consumption. The final performance also interacts with antenna matching, encapsulation and installation environments.

The procurement requires verifiable models, data manuals and label-setting conditions.

The size of the chip affects only part of the cost of the entire label, and antennas, sealing, binding are as important as good rates. A smaller process does not solve problems if the main loss comes from unreliable installation.

Put this in a specific process.

Even if the two chips are programmed differently, the whole label performance can be dominated by a difference between antennas and adhesives. If you change the chip at the same time, the antennas and the seals, you cannot attribute the result to the process. To answer technical questions, you must first allow comparison to change only the variables associated with the problem.

Process distribution is of more diagnostic value than individual qualified findings

When performance moves closer to the failed border, the two-digit statistics of qualification and non-conformity may not change for the time being. The retention of test configurations and distribution of results will help identify batches of material, process drifting or equipment changes. The reference is used to monitor the testing system, while the marginal samples are used to observe abundance, which is different. The improvement measures should be compared back and forth under consistent conditions, and it should be verified that no bad transitions to subsequent processes have been made.

From demonstration to delivery, what evidence is needed

Observation dimensions Evidence to be retained
Process Retroactivity Material batches, platforms and process versions are available for inspection
It's consistent. Comparison of thresholds and dispersions under the same conditions
Bad closed circle The results of the failure analysis return to design or process
This is the key trade-off. What would support a procurement decision if the supplier gave only the nodes of the procedure without specifying the conditions for testing?

It's recommended that this be verified.

Comparison of candidate chip options under the same antenna and installation conditions, with a record of minimum available power, reading and writing differences and batch separation.

It is recommended that raw materials, process parameters, detection configurations and poor types be recorded in batches and that electrical failure be separated from appearance failures.

It's worth asking.

What would support a procurement decision if the supplier gave only the nodes of the procedure without specifying the conditions for testing?

Technical and factual references