Issues arising in the area of container applications
Industry News

Issues arising in the area of container applications

PublishedShanghai Zejie Smart Technology Co., Ltd.
1. How Container Transport Conditions Affect Electronic Tag Performance
The use of electronic labels in container transport is highly specific compared to applications in areas such as industrial automation.
(1) The working environment is harsher
The label must be designed and sealed taking into account the following factors:
The temperature characteristics of the container are high, very different and all-weather.
High humidity working environment Most of the time during container transport is completed at sea (or in inland waterways), and thereforeTagIt is important to be able to work in an environment of 35-80% humidity.
The long, high-intensity UV exposure speeds the ageing of labeled case plastic.
The container works mostly at the docks and sea, where labels are required to resist acid corrosion while sealing structures and materials are resistant to vibration impacts.
(2) Tab Dynamic Read
Because of the speed with which containers circulate, container information must be accessible from a distance, so electronic labels are required to identify at high (move speed > 100 km/h), distance (>6 m), accuracy rate (>99%) etc. #p#subtitle#e#e#container is subject to metal surface impact analysis #e#e#
2. Analysis of the impact of the electronic labelling of containers on surface metals
The normal RFID label is attached directly to the metal surface, and because of its reaction to the in-charge electromagnetic wave, there will be a strong back-direction electromagnetic wave going through the electronic label. The addition of the input wave to the reflection phase will offset part of it, and the intensity will be significantly reduced, seriously affecting the reading distance of the reader to the RFID tag, even from the data on the RFID label, as shown in figure 2. At the same time, the magnetic fluxes that occur between the readers and RFID labels will be felt by the metal surface vortex, which, according to the law of the twirth, will reverse the magnetic field of the reader, causing a strong decline in the magnetic field on the metal surface.
One way to counteract the effect of a container's metal surface is to increase the spacing between the antenna and the metal. As the spacing grows, the resultant field vector increases. It peaks at a quarter wavelength, yielding a gain of 3 dB. When an RFID tag is attached to a metal container, however, there is little room to raise it far enough. For example, a quarter wavelength at 900 MHz is about 8 cm, while the groove on the exterior of the container is only 2 cm deep. A dielectric spacer must therefore be placed between a conventional electronic tag and the metal surface. In the formula for the wavelength of an electromagnetic wave in a medium, λ0 is the free-space wavelength, and μ and ε are the permeability and permittivity of the medium, respectively.
The usual approach is to integrate the quarantine medium with the electronic label, thus creating a metal-resistant electronic label. The studies that need to be done include media research (selection of the medium, test and process determination, etc.), data analysis for specific media parameters (m, thi) and choice of form of containment.