Material Detection: Discovering the principles of application for M1 cards
RFID Knowledge

Material Detection: Discovering the principles of application for M1 cards

PublishedShanghai Zejie Smart Technology Co., Ltd.

The so-called M1 card usually refers to the market name of some MIFARE Classic compatible products, but the specific chip type and capability should be based on information.

Card materials, information carriers and business vouchers should be selected separately

Magnetic, bar code, contact chip and non-exposure chips are different information carriers and PVC materials are only part of the card.

M1-card principles cannot be inferred from the card material.

The cards are used in a combination of antennas, chips and seals. Business security also depends on key configuration and back-office authorization.

For the new system, it is not appropriate to ignore safe migration because of the extensive compatibility of old equipment. Nor can compatible chips from different sources be considered fully equivalent.

The M1 card is often a broad name in the procurement, and an accurate chip series and support function should be identified. The card material does not support the chip version or read the numbering or the authorization security.

Put this in a specific process.

One system may read UID and open the door, another one may verify the controlled document before authorizing it. Even using the same card, a different security border is involved. M1 cards should be discussed first to check what mechanism is actually used in the system, rather than replacing risk analysis, as they are commonly called.

Production quality should be accepted and accepted along with the certificate life cycle

When the card is delivered, it undergoes distribution, commissioning, hanging, replacement and exit. These conditions are not necessarily linked to the integrity of the physical card. The design should clearly link the card number, electronic identification and back-office identity, and specify which information allows for change. Individualized mass production also requires that the face of the card is not mislocated with electronic data.

Let's look at the input and the results.

Observation dimensions Evidence to be retained
Information carrier Card materials are identified separately from chip/magnetic strip capabilities
Production consistency Print, coding and readable information
Service cycle Back-up cards, loss of hangers and batch retroactive schemes
This is the key trade-off. Are the facilities for keeping old equipment compatible and locking out secure borders that are unacceptable in the coming years?

It's recommended that this be verified.

Check the chip model, the reader capacity and key management to test if lost, filled cards and rights revocations are effective at all terminals.

It is recommended that you use a physical terminal to validate the code, read cards, abnormally hung and filled card processes, and then try to bend, wear or tear, and clean.

It's worth asking.

Are the facilities for keeping old equipment compatible and locking out secure borders that are unacceptable in the coming years?

Technical and factual references