Why are your RFID printer parts always bad? Maybe they're missing these key points. | Shanghai Zejie Smart Technology Co., Ltd.
Why are your RFID printer parts always bad? Maybe they're missing these key points.
In modern business operations that rely on RFID technology for efficient management and information labelling, RFID printers are important equipment. Guaranteeing the service life of their components not only reduces the loss of stoppages due to equipment failure but also enables more effective control over the cost of the enterprise. The following are key aspects that need attention in order to improve the useful life of RFID parts.
Print headers are the core parts of RFID printers, whose state directly affects the quality of printing and the stability of operation of equipment. In daily use, the head is overheated. A large number of labels are printed over a continuous period of time, which can cause excessive heat to print hair and accelerate wear. It is recommended that after printing a number of labels in consecutive times, appropriate time breaks be set to allow the head to heat naturally. At the same time, the high-quality tape and sticker matching the printer must be used. The poor waste material may have rough surfaces, scratching the head during printing, or ink content is incompatible with the headprint, causing congestion. Use special cleaning tools on a regular basis, and clean the remaining ink on the head of printing with a small amount of light, keeping the head of printing... and sensibilities, to extend its useful life.
Printers need to maintain their moving parts, such as gears, belts, etc... They are checked regularly for any looseness and signs of wear or tear. If the gear is missing, the belt is loose or fractured, it should be replaced in a timely manner. When used daily, make sure that the environment is clean, avoid dust, and scrap into the moving components, which will increase friction between the components and reduce the useful life. When printers run, if you hear abnormal frictions or carton sense, you need to stop immediately to check the moving parts and prevent failure from spreading.
Ink/belt supply systems should also not be ignored. For ink cartridges or carbon belts, they should be installed in the right way, avoiding tilting or non-installation, which could lead to ink/band insulation, affect printing effects and increase internal pressure on the system, damage associated components. Regular cleaning of pipes and interfaces for ink/band delivery systems to prevent congestion from piled up with ink or colour bands. At the same time, select ink and carbon belts of reliable quality, their fluid supply properties can help reduce system loads, and extend the use of ink/band parts.
In addition, electrical components of equipment are more affected by voltage fluctuations. To prevent the loss of circuits by voltage instability, RFID printers should be connected with a pressurer to ensure that the equipment works in a stable voltage environment. Periodically check power lines, data lines and other connections such as broken, ageing, timely replacement, and guarantee the stability of signal transmission and electricity supply, thereby extending the overall service life of the equipment.

Ms. Lei
Mr. Pang