RFID technology makes cars more efficient.
Industry News

RFID technology makes cars more efficient.

PublishedShanghai Zejie Smart Technology Co., Ltd.

“RFID technology makes cars more efficient” easily confused manufacturing management improvements with engine physical performance. Labels do not directly increase combustion efficiency or power output.

Automatic recognition must access the process state, not by-pass display

Reading success should only be the input of a process judgement and cannot skip the locking or security control of the device.

The engine's power cannot be enhanced by a label.

RFID may help to identify parts, process routes and maintenance records, thereby reducing misloading, leakage or formulation errors. To claim fuel consumption and power improvement, independent engineering design and test data are still required.

The value of the production of a retroactive system should be evaluated on the basis of evidence of error prevention and quality, and indirect management effects cannot be recast as unproven performance indicators.

The identity-proofing of engines reduces the error in the design, the misformulation and the missing process, but it is a benefit to the quality of the process. Power, fuel consumption or life improvement still needs to be designed and tested independently. Distinguishing indirect contributions from direct performance will enable an accurate evaluation of RFID project value.

Put this in a specific process.

If RFID helps to prevent the wrong parts from entering assembly, it can reasonably discuss making them; if you want to claim that engine power is up, you need independence to test. To be accurate, where improvements occur will not diminish technical value, but will make input and acceptance targets more verifiable.

Split end-to-end beats into positionable time

From work to identifiable areas, to action by the device, usually through triggers, reading, validation, interface transmission and control response. Each section may be waiting, and normal averages do not represent the most unfavourable condition. If a judgement is needed in a limited window, the delayed distribution of the entire link should be measured and the safety or business status of the service after time has elapsed should be clarified. Only wireless reading can be optimized, and no interface queued; only additional software retesting may also make an old task effective after the work has been removed.

Let's look at the input and the results.

Observation dimensions Evidence to be retained
Process Map Can you match the correct work with the same re-use?
beat impact Time for recognition, verification and response
Unusually isolated. Identification anomaly cannot be extended to an uncontrollable line.
This is the key trade-off. Is the real improvements that technology brings occur in product performance or is it less wrong in manufacturing processes?

It's recommended that this be verified.

The mass and back-to-work tests of the work identification associated with the process version were conducted to verify that errors had been stopped in time, rather than being shown for reading only.

It is recommended that production events be recorded in the observation mode, which does not change the action of the equipment, and that the worksheets, works and processes be checked for consistency before they are gradually entered into production judgement.

It's worth asking.

Is the real improvements that technology brings occur in product performance or is it less wrong in manufacturing processes?

Technical and factual references