RFID spare parts production line management programme
Industry News

RFID spare parts production line management programme

PublishedShanghai Zejie Smart Technology Co., Ltd.

The RFID spare parts production line programme often uses pallets or swingboxes to reduce the cost of labelling, but recycled loads carries the risk that binding will expire.

The parts management should prevent the identity of the product from being impostored.

The system needs to express the remaining collections and cannot continue using the original complete list.

The record of "traces to the slot" is not sufficient to demonstrate that all parts and components have been processed or tested in the same manner.

The old formulation may be misapplied to the new parts if only the package is believed to have been coded. The folder confirmation, untie and return should be a clear event, avoiding an error link being continuously magnified downstream.

How do border conditions change the conclusion?

There are several parts in the same tray, one of which is taken back to work, and the rest of the collection changes. If quality conclusions are still performed by a whole-carrying, the individual condition may be inherited by mistake. The vehicle tracking down costs requires that some of the changes be given a sufficiently clear expression capability.

It's recommended that this be verified.

Arrange for re-entry of empty tanks, leaks, refuelling and back-to-work to verify that the worksheets, loads and spare parts have always been serial numbers.

It is recommended that production events be recorded in the observation mode, which does not change the action of the equipment, and that the worksheets, works and processes be checked for consistency before they are gradually entered into production judgement.

Automatic recognition must access the process state, not by-pass display

Reading success should only be the input of a process judgement and cannot skip the locking or security control of the device.

Split end-to-end beats into positionable time

From work to identifiable areas, to action by the device, usually through triggers, reading, validation, interface transmission and control response. Each section may be waiting, and normal averages do not represent the most unfavourable condition. If a judgement is needed in a limited window, the delayed distribution of the entire link should be measured and the safety or business status of the service after time has elapsed should be clarified. Only wireless reading can be optimized, and no interface queued; only additional software retesting may also make an old task effective after the work has been removed.

How many bases do you have to decide what's worth?

Observation dimensions Evidence to be retained
Process Map Can you match the correct work with the same re-use?
beat impact Time for recognition, verification and response
Unusually isolated. Identification anomaly cannot be extended to an uncontrollable line.
This is the key trade-off. Has the reduction of the individual sticker cost increased the hidden costs that cannot be proved in a single case?

It's worth asking.

Has the reduction of the individual sticker cost increased the hidden costs that cannot be proved in a single case?

Technical and factual references