I'll teach you how to install RFID.
You want to install a RFID door-barrier system for the site, you're worried about complexity of operation? Don't worry, even White can do it easily after the next step.
Before installation, prepare for work. The list of confirmed devices, including RFID readers, controllers, door locking, power, RFID cards, management software and associated screws, wire parts, etc., is planned to be installed, the reader recommends that it be placed at a distance of 1.3 - 1.5 metres from the ground, to facilitate personal brushing; the locking of doors is subject to choice of suitable means of installation and location according to the type of door (wood, iron, etc.).
When you start installing, step to connect the line. Connect the data lines of the readers with the controller interface, and keep an eye on the positive-negative polar and line sequence; the power line one end connect controller, and the other end access the power plug. Then, install a door lock, perforate the doors and doors, fix the locks and tongues, and then connect the locks to the controller.
After hardware is installed, go into the installation and debugging phase of software. Install the management software to a computer, connect the controller to the computer through data lines. Open the software, set up system parameters such as adding user information, allocating permissions, setting open hours, etc. Upon completion of the settings, perform tests, use RFID cards close to card readers, check whether the door lock is properly opened, shut down, and test alarm functions, alarm alerts, abnormality tips, etc. If you have problems, check the book line connection, parameter setting, etc.
These steps will allow for the successful implementation of the RFID gate-ban system, which will provide additional security for site security.

Ms. Lei
Mr. Pang