How do we extend the service life of UHF RFID without dry rubber tags? Environmental factors and maintenance techniques
Environmental factors play a crucial role in extending the useful life of UHF RFID non-dry glue labels....... It is important to avoid long-term exposure to extreme temperatures, such as temperatures above 60°C, which can lead to labeled film layers softening, deforming and even melting, thus losing viscosity and being unable to bind firmly to the surface of an object. In addition, the wet environment is also a major enemy of RFID labels, and it can easily lead to short circuits or oxidation of internal circuits for the tags, thereby damaging the chip and affecting its normal reading and writing functions. So, as much as possible, you should keep the labels in dry, ventilated places, so that they are not damped.
In addition to temperature and humidity, the damage caused by chemical corrosive substances to RFID labels cannot be ignored. In some special industrial or chemical experimental environments, there are various corrosive substances such as acid alkali that, once exposed to the label surface, can corrupt label material, damage its structure, and cause chip damage. Therefore, in this environment, effective protection measures must be taken, such as the use of protective film cover tags.
In our daily maintenance, we should also be careful to avoid frequent friction of label surfaces. Because the antenna of the RFID tag is usually a relatively fine conductor line, frequent friction can cause the antenna to wear and break, thus affecting the stability of signal transmission. So, when using and storing the tags, you have to take them lightly, so as to avoid contact with rough, sharp objects.
When pasting RFID labels, it is also essential to ensure that the surface is clean and dry. If there is dust on the surface, impurities like oil pollution, this affects the stickyness of the labels, which makes them easy to remove. So, before pasting, you should wipe the surface with a clean cloth and make sure that it's... dry and then paste, so that the sticker is significantly more sticky and more firmly attached to the object.
For long-term RFID labels, we should also regularly check their reading properties. Because over time, labels can age for various reasons, such as loss of glue and loss of chip performance. Through regular checks, we can find these ageing labels in time and replace them to ensure that the system is functioning properly and data is safe.
In conclusion, to extend the life of UHF RFID without dry glue labels, it is necessary to take a comprehensive approach to protection from environmental factors, routine maintenance, paste methods and periodic inspections. Only then can the RFID tags be stable in applications that work reliably, facilitating our lives and work.

Ms. Lei
Mr. Pang