Characteristics of high temperature rfid tags
How much tolerance is just the starting point for a high temperature-resistant RFID label. The real easy to ignore is whether the label should be read in heat or after leaving the hot zone? These two tasks require different requirements for chips, seals and antennas.
Disassembly the temperature-resilient parameters into three different questions.
Select the heat-resistant label, which is to separate the storage from the temperature-resilient work and cycle life. The label is to be cooled, not to mean that it can be read in the oven; a short pass does not mean that after repeated heat swelling and cold contraction, it remains reliable. Seal, antenna connection, chip attachments and fixed glue can be part of the pre-defunct.
Heat resistance is not the same as reading in heat.
The continuous temperature protection and short-term peaks shall be agreed separately. If the label is fixed to metal work, changes in thermal, coating and stationary materials of the work are also considered; the air temperature is the same, not as having experienced the same heat process within the label.
The temperature limit is written directly as a use of temperature, which conceals the cycle ageing.
The input for reusable labels should be distributed over the actual turnover, and the amount of material spent on them should be more relevant to the reliability of the adoption. Frequent changes in labels may offset the automatic identification of the saved labour, so that the replacement, the binding and the decommissioning process are also costed. The temperature-resistant selection ultimately serves the stabilization process, not the specification competition.
Put this in a specific process.
Imagine the same labels having a short, high and low temperature at long temperatures: the former look good, which does not prove that the latter can pass. Thermal transfer, the duct age and the connection stress have different time processes. So acceptance requires covering the real temperature curve, rather than looking for the highest numbers on specifications alone.
Why the temperature limit is not enough to describe life.
Thermal ineffectiveness is not only one form of work that the chip stops at short notice. Different materials may overwhelm and contract, and connective fatigue; the ducts and seals can change over time. This requires testing to keep temperature, duration and frequency of three messages. If equipment is read only after cooling, it should be evaluated separately for survival after high-temperature processes and chain stability after cooling. Both results are passed, so they match the process's objectives. Compressing these amounts to a maximum temperature makes it difficult for buyers to compare two seemingly identical specifications.
From demonstration to delivery, what evidence is needed
| Observation dimensions | Evidence to be retained |
|---|---|
| Process boundary | Maximum temperature, duration, cooling method recorded separately |
| Aging results | Read stability before and after the same sample cycle |
| Install Reliability | Freezing, warp and surface contamination are registered separately |
| This is the key trade-off. | If they are not read before cooling, do production processes still receive sufficient timely information? |
It's recommended that this be verified.
Select the different installation locations to record temperature and reading results near the label; retrospect the original as it is going through multiple process cycles, and determine whether decay can be repeated.
It is recommended to use the same sample to record initial reading and writing baselines, reheating, cooling and washing in real process, and to record the appearance, fixed status, reading and writing results for each round. Keep serial numbers and process records on failed samples, not just put a new label on to continue with the demonstration.
It's worth asking.
If they are not read before cooling, do production processes still receive sufficient timely information?

Ms. Lei
Mr. Pang