Plants implemented RFID technology for retrofitting production and management systems
The introduction of RFID should not start with “loading each site with a reader”. First, it is possible to determine which jobs are worth collecting automatically by identifying the material at which intersection.
The plant is changed by the information flow, then control.
The device and the work may be a one-on-one, circular binding or more than one ton.
A single centralized feed will expose both wireless, interface and operational problems.
It is advisable to have the system recommend it before gradually granting control. For example, you can either signal false material, observe false or missing reports, or decide whether to lock off the switch.
Automatic recognition must access the process state, not by-pass display
Reading success should only be the input of a process judgement and cannot skip the locking or security control of the device.
Split end-to-end beats into positionable time
From work to identifiable areas, to action by the device, usually through triggers, reading, validation, interface transmission and control response. Each section may be waiting, and normal averages do not represent the most unfavourable condition. If a judgement is needed in a limited window, the delayed distribution of the entire link should be measured and the safety or business status of the service after time has elapsed should be clarified. Only wireless reading can be optimized, and no interface queued; only additional software retesting may also make an old task effective after the work has been removed.
An easily ignored reversal.
If the old process is one that workers choose by working singles, the new process is automatically selected by a reader. Automation may make the error more consistent if the worksheet is inherently tied wrong. Therefore, it should check the data source and keep it in contrast at the controlled stage, then gradually hand over control, rather than mismanaging stabilization implementation correctly.
Put your judgment in the real situation.
A full shift is recorded by side to review back-up, switch and empty trays; the identification check is then passed with limited process judgement.
It is recommended that production events be recorded in the observation mode, which does not change the action of the equipment, and that the worksheets, works and processes be checked for consistency before they are gradually entered into production judgement.
How many bases do you have to decide what's worth?
| Observation dimensions | Evidence to be retained |
|---|---|
| Process Map | Can you match the correct work with the same re-use? |
| beat impact | Time for recognition, verification and response |
| Unusually isolated. | Identification anomaly cannot be extended to an uncontrollable line. |
| This is the key trade-off. | Is the standard for success in retrofitting more screen data or is it that back-to-work and misdeeds are prevented earlier? |
It's worth asking.
Is the standard for success in retrofitting more screen data or is it that back-to-work and misdeeds are prevented earlier?

Ms. Lei
Mr. Pang