Shanghai-Shanghai Smart Technologies Co. Ltd.: The leading card producer
RFID Knowledge

Shanghai-Shanghai Smart Technologies Co. Ltd.: The leading card producer

PublishedShanghai Zejie Smart Technology Co., Ltd.

The choice of a card producer cannot be based solely on the term “leading.” Information useful to the buyer is whether the product is compatible with the end, whether the batch is consistent, and whether it can be traced back after an error.

Card production capacity should be supported by evidence delivery

The ability of Shanghai to select a specific project should be verified with a sample card, confirmation of documents and actual delivery information.

Designing, printing, chip selection and coding are not independent tasks. Delivery fails when it is well-dressed but the code is duplicated or the card is good enough to be read by the on-site device.

The sample card should identify the face, protocol, code, terminal and version. Signs only recognize printing effects, leaving communication problems to a post-natal level.

Situations requiring early verification

The sample card confirms that it should be designed, that business is involved with end-users. The designer sees the correct pattern, and the operator sees the complete list, and none of them can replace the end-test. The identity object is written clearly, so that all parties after delivery say "no problems with their own acceptance."

It's recommended that this be verified.

(c) To confirm the results of the sample card on the actual terminal before a quantitative birth and to store the face, code rules and test versions of the card and agree on the treatment of the bad.

It is recommended that you use a physical terminal to validate the code, read cards, abnormally hung and filled card processes, and then try to bend, wear or tear, and clean.

Card materials, information carriers and business vouchers should be selected separately

Magnetic, bar code, contact chip and non-exposure chips are different information carriers and PVC materials are only part of the card.

Production quality should be accepted and accepted along with the certificate life cycle

When the card is delivered, it undergoes distribution, commissioning, hanging, replacement and exit. These conditions are not necessarily linked to the integrity of the physical card. The design should clearly link the card number, electronic identification and back-office identity, and specify which information allows for change. Individualized mass production also requires that the face of the card is not mislocated with electronic data.

From demonstration to delivery, what evidence is needed

Observation dimensions Evidence to be retained
Information carrier Card materials are identified separately from chip/magnetic strip capabilities
Production consistency Print, coding and readable information
Service cycle Back-up cards, loss of hangers and batch retroactive schemes
This is the key trade-off. Is the supplier presenting a beautiful sample or is it a quality process that can produce the same results on a sustainable basis?

It's worth asking.

Is the supplier presenting a beautiful sample or is it a quality process that can produce the same results on a sustainable basis?

Technical and factual references