Magnetic card: Safety, convenience and development prospects
A magnetic card usually has advantages from mature equipment and simple interactions, and its security cannot be derived from “brushing up for convenience.” A discussion of development prospects should start with a distinction between different operations such as storage values, door closures, membership recognition, etc.
Card materials, information carriers and business vouchers should be selected separately
Magnetic, bar code, contact chip and non-exposure chips are different information carriers and PVC materials are only part of the card.
Accessibility and security require different evidence
The static information carried by the magnetic bar is not on the same level as the back-office account. Even if the face or material has been replaced, the risk mechanism remains unchanged if the business is authorized only with replicable static content.
The transfer of the magnetic strip to the chip does not allow for the omission of privileges, loss of a hanger and terminal management.
The ease also includes the cost of recovery after the loss. The old vouchers are not synchronised when the card is filled, and the time when offline equipment is updated determines experience and risk.
Put this in a specific process.
Assuming that the card saves only one member number, consumer rights are approved from the back desk; even if a number is copied, it does not automatically get all of it. Conversely, if the backstage believes in this number unconditionally, a more beautiful card would not change risk. Design discussions will follow the authorization chain, not just the content of the card.
Production quality should be accepted and accepted along with the certificate life cycle
When the card is delivered, it undergoes distribution, commissioning, hanging, replacement and exit. These conditions are not necessarily linked to the integrity of the physical card. The design should clearly link the card number, electronic identification and back-office identity, and specify which information allows for change. Individualized mass production also requires that the face of the card is not mislocated with electronic data.
Let's look at the input and the results.
| Observation dimensions | Evidence to be retained |
|---|---|
| Information carrier | Card materials are identified separately from chip/magnetic strip capabilities |
| Production consistency | Print, coding and readable information |
| Service cycle | Back-up cards, loss of hangers and batch retroactive schemes |
| This is the key trade-off. | Is the system believing in a card or is it verifying an avoidable business certificate? |
It's recommended that this be verified.
Checking business chains with old cards for failure, repeatcards, offline terminals and patches, keeping the rules of authorization consistent when comparing different carriers.
It is recommended that you use a physical terminal to validate the code, read cards, abnormally hung and filled card processes, and then try to bend, wear or tear, and clean.
It's worth asking.
Is the system believing in a card or is it verifying an avoidable business certificate?

Ms. Lei
Mr. Pang