RFID scanning equipment cost component: 7 major elements of the chip selection to mass production process, Shanghai-based Smart Technologies Ltd.
RFID Knowledge

RFID scanning equipment cost component: 7 major elements of the chip selection to mass production process, Shanghai-based Smart Technologies Ltd.

PublishedShanghai Zejie Smart Technology Co., Ltd.

Key components account for up to 60% of the cost, with the main controller chip and RF module being particularly important. Imported chips, such as the NXP series, cost 3–5 times as much as domestically produced chips but offer better power management and interference resistance. Using domestically produced chips with an in-house RF circuit can cut costs by at least 30% while maintaining performance. Antenna materials (copper, aluminum, or flexible circuit boards) and manufacturing methods (etching or printing) directly affect the balance between manufacturing cost and performance.

The more the SMT sticker is automated, the lower the cost of a single piece of the unit is, but the pre-package input is in excess of millions. When small batch customizations are produced, the increased share of hand-welding leads to a better yield rate below 85%. The antenna is achieved through modular design, and the preassembling of chips and circuit boards reduces production costs by 25% and improves product consistency.

Module integration affects bill of materials (BOM) costs. Integrating the RF module, MCU, and power management on a single PCB cuts interconnection costs by 20% compared with a discrete-component design, but requires more advanced packaging. In testing, switching from conventional wired tests to over-the-air (OTA) testing increases efficiency threefold and requires only 10% additional investment in test equipment.

The best supply chain management can... reduce costs. Establish a long-term cooperative system of component suppliers that can reduce the impact of raw materials fluctuations by 40% by pre-locking exchange rates and volume purchase agreements. At the manufacturing end, introducing digital management systems to monitor production losses in real time increases the utilization rate from 92% to 98%.

In addition, certification standards (e.g., FCC/CE), software authorization costs, and packaging transport costs also have an impact on the total cost of 15-20%. By establishing localised certification laboratories and using open source software structures, one-million-scale savings can be achieved in compliance to create sustainable profit space for manufacturers.