What's the RFID against metal label?
Industry News

What's the RFID against metal label?

PublishedShanghai Zejie Smart Technology Co., Ltd.

The RFID anti-metallic labels address mainly the difficulty of reading and writing in the vicinity of metals. It is not a universal label that “is as good on any metal” or, much less, a pronoun against reproduction or leaking.

The issue of the metal environment must be discussed with an installation structure

Metals change the electromagnetic environment around labels, matching antennas that used to work in the air and changing radiation conditions. Improving these conditions through specialized design does not mean that all metals, curvatures and installation positions can achieve the same effect. The three different test situations are those where labels are embedded in a dent, placed on curved crusts and placed on flat steel plates.

Anti-metallics are electromagnetic. They're not safe.

The label may improve performance by means of special antennas, isolation structures, etc., but the effects are still associated with the size, curvature and direction of the installation. A screw, glue or embedded fixation also changes conditions on the site.

If you have been tested on a flat steel plate and then you have been fed directly to the small diameter pipe, the selection conclusion may be invalid.

The purchase comparison should lock the actual installation, so that each party does not select the most advantageous metal base. The cleaning and dismantling samples should be re-detected. The new product can read in its state, but only proves to be suitable for initial fitting, cannot represent a rubber installation, and the containment and mechanical anchoring remain valid throughout its life cycle.

Why isn't one success enough?

If the label is normal on a large steel plate, change to a narrow metal frame and change it, not to consider the batch as bad. The base plate condition is part of an antenna system. Compare with the same work, confirm that the failure moves with the label or with the installed structure, then decide on the liability for the overhaul.

Disassembly failures into chain changes and business changes

Labels receive working energy and send information back to the reader are relevant but different links. Structural changes in metal proximity may affect one or two of them at the same time. In addition to seeing whether it is readable, testing should focus on what configuration is needed to stabilize work and whether this configuration expands.

How many bases do you have to decide what's worth?

Observation dimensions Evidence to be retained
Effective Installer Level, Curve, Tile.
Identification of borders Record available areas, and also areas where adjacent items have been read
Maintenance costs Whether to retie and verify after replacement
This is the key trade-off. Are you buying a label or an identification that can be delivered under specified installation conditions?

It's recommended that this be verified.

Prepares a sample of the flat, curve and dim position, measuring the stable identification area using the same reader configuration and recording locations that cannot be reliably read.

The location of the installation, the direction of the label, and the surface processing can be used as three variables, with a fixed reader and an antenna being changed after each item. Saves a map to read success and failure, then decides whether to add the antenna or replace the tag; increases the launch power directly, possibly simultaneously expanding the serial reading range.

It's worth asking.

Are you buying a label or an identification that can be delivered under specified installation conditions?

Technical and factual references