Application scene for RFID labels
Industry News

Application scene for RFID labels

PublishedShanghai Zejie Smart Technology Co., Ltd.
Whether it is a source RFID or an passive RFID, its role is to identify goods, but their applications vary from one place to another and in the traditional logistics system they are sourced.RFIDIts strong signal and wide coverage make it common in warehousing. Passive RFID is often used in transportation to tightly control shipment quantities and security.
The active RFID application is used to track or monitor the arrival of pallets, packagings and goods in and out of the warehouse. When entering the warehouse, the goods may have been labelled with RFID, or they might need to initialize the label, enter information about the goods, and then paste them on the goods.
In traditional logistics transport modes, each stop requires a terminal sweep to confirm that the goods have reached their operational centre accurately.
In the case of different cargoes in the same vehicle, mostly the passive RFID label is used because the sensor range for the passive tag is relatively small and within 60 cm, by scanning each one, there will be no scanned sensor error.
The specific case can be referred to the electrician logistics, and every shipment reaches its centre, with a unique scanned identification. The advantage of this is that data are accurate, there are fewer errors, there's a bad thing that if the goods are scattered, it takes more time to scan each one, and it's easier to lose the goods, and it's easier to lose them.
The source RFID application is located in the area where goods need to be monitored and tracked, and the field environment is planned to deploy an active reader, according to radio frequency, which will ensure coverage of the range and signal strength as well as wireless access point planning for wireless local area networks.
The source RFID sense is as high as 30 meters, and if this high-frequency output is so strong, why can't it be used for transport in transit? Because the current disk electronic labels are only for sensor recognition, do not allow for analytical information management of goods, use active RFID sensing, cannot read what the cargo is, and are very vulnerable to sensory errors.
Thus, in traditional logistics systems, the source applications are in storage and the passive applications in transport.
If there's a source, no source RFID that can be compatible...