RFID Active Label Maintenance Guide: The secret to long useful life and ensuring a stable operation
The RFID active tags are widely used in areas such as asset tracking, logistics management, and vehicle management, with their longer identification distance and greater storage capacity. Unlike passive labels, the source labels contain batteries inside to provide energy for their signal launch. Therefore, special attention is needed for maintenance of the active tags, especially in battery management. Correct maintenance can... extend the useful life of the labels and ensure that they work in a stable and reliable manner. This paper will describe in detail maintenance matters where the RFID source labels require attention in daily use.
Periodically inspect battery capacity: The batteries that are under-charged are replaced in a timely manner by means of periodic checks on labeled battery power by reading and writing machines or management software.
Select the appropriate battery type: Use the type and specifications of the battery recommended by the manufacturer to avoid using a poor or non-compliant battery.
Correct replacement of batteries: When replacing batteries, the action shall be in accordance with instructions to avoid damage to the internal circuits of the label.
(b) The label should be lightly applied during use and transport to avoid collision or fall.
Avoiding pressure: Avoid placing heavy weight on labels to avoid damage to label casings or internal circuits.
Fixed installation: For a fixed-use label, appropriate installation should be used to ensure its reliability.
Following the protection level: View the label ' s protective level (IP level) and select the appropriate use environment according to its water-proofness.
Cleaning labels: Regular cleaning of label surfaces to avoid dust and dirt affecting their performance.
Avoid immersion: Even waterproof labels should avoid long periods of immersion in water.
(b) Distance from sources of interference: When used, as far as possible from high power wireless equipment such as microwave ovens, electric appliances, etc.
Rational antennas: For multilabel applications, labels and readers antennas should be reasonably placed to avoid interference with each other ' s signals.
Frequency settings: Rationally set the working frequency of readers and labels to avoid frequency conflicts, depending on the physical environment.
The maintenance of RFID active tags is an important day-to-day task, by focusing on battery management, avoiding physical damage, water protection from dust, signal interference, software updating and professional maintenance, which can effectively extend the useful life of labels, ensure their stable and reliable work, and provide continuous support for your applications. I hope this will help you to better maintain the source tags that are used to make them...

Ms. Lei
Mr. Pang