Guidelines for the use of RFID against metal labels: mastering key techniques to improve application effectiveness
RFID is resistant to metal labels Designed for the metal environment and can work normally on or near the metal surface, but needs to be used with some attention to ensure performance and useful life.
..., the location of the installation is essential. Anti-metallic labels should be closely tied to the metal surface to ensure that there is no air or other medium between the label and the metal, otherwise they affect the transmission of signals. At the same time, it should be avoided to place the label on the edge of the metal or on a sharp and sharp upturned part of the metal so as not to damage the label.
Second, the installation of an environment needs attention. Although metal labels can resist metallic interference, their performance may be affected in a strong magnetic field environment. Therefore, as far as possible, they should be installed without approaching such powerful magnetic field devices as large electric power, transformers and so on. In addition, high temperatures, wetting and other bad conditions can cause damage to labels, and use in these environments should be avoided as much as possible.
Furthermore, the way in which labels are installed affects their performance. It is recommended that the label be fixed to the metal surface with a special glue or tape to ensure that it remains strong and unfavoured. In the installation process, overstretched or bent labels should be avoided so as not to damage chips and antennas inside the label.
Also, the distance to read a label needs to be noted. The distance to read against metal labels is relatively short, usually between a few and several dozen centimetres. In practical applications, the appropriate reader should be selected according to specific needs, and the power of the reader and the antenna direction adjusted to ensure... the reading effect.
... regular inspection and maintenance are essential. Periodic check if the label is damaged, dropped, etc., and replace the damaged tag in a timely manner. Meanwhile, keep the label surface clean to avoid dust and dirt affecting signal transmission.
The correct use of RFID Zon-metal tag is an effective way to improve efficiency and system stability. Follow the above-mentioned attention, properly install and maintain labels that can fully exploit their advantages in the metal environment and provide strong support for your business development.

Ms. Lei
Mr. Pang